Applied Air Leakage Checks - ONLINE CDL SCHOOL

Practice free. No account needed.
Want your scores, test history, and progress in your driver dashboard? Create a free account or log in before starting to save your results.

Applied Air Leakage Checks

Build confidence with 10 original questions about Applied Air Leakage Checks. Review your answers and explanations after finishing.

Supplemental study practice. This is not a government licensing exam or ELDT certification, and does not replace hands-on training. Follow your state’s current handbook.

1 / 10

When performing an applied air leakage check on a combination vehicle, what is the maximum air pressure loss allowed in one minute?

Three psi

Five psi

Two psi

Four psi

2 / 10

If the air loss rate during the applied air leakage check is too high, what could happen if you drive the vehicle?

The air compressor will overheat

The brake lights will stay on

The parking brake will not release

You could lose your brakes while driving

3 / 10

What must be done before starting the applied air leakage check?

Apply the parking brake and turn off the engine

Release the parking brake and start the engine

Build air pressure to governor cutout, shut off engine, chock wheels, and release parking brake

Reduce air pressure to below 55 psi

4 / 10

During the applied air leakage test, how long should you hold the foot brake to measure the pressure drop?

Five minutes

Two minutes

One minute

Thirty seconds

5 / 10

Why is it important to chock the wheels before performing the applied air leakage check?

To prevent the vehicle from moving when the parking brake is released

To help the air pressure build faster

To keep the brake lights on during the test

To ensure the air compressor is working

6 / 10

After the air system is fully charged, what is the first step in conducting an applied air leakage check?

Chock the wheels

Apply the parking brake

Release the parking brake

Turn off the engine

7 / 10

When performing the applied air leakage check on a combination vehicle, what additional step must be taken before applying the foot brake?

Turn on the engine

Release the tractor protection valve

Drain the air tanks

Apply the parking brake

8 / 10

During an applied air leakage check on a single vehicle, what is the maximum air pressure loss allowed in one minute after fully applying the foot brake?

Five psi

Two psi

Three psi

Four psi

9 / 10

What should you do if the air pressure drops more than the allowed amount during an applied air leakage check?

Release the parking brake and try again

Continue driving and monitor the gauges

Increase engine speed to build pressure

Check for air leaks and repair before driving

10 / 10

What is the purpose of the applied air leakage check during a pre-trip inspection?

To test the low air pressure warning signal

To ensure the air brake system does not lose too much air when brakes are applied

To verify the parking brake holds the vehicle

To check if the air compressor is working

Your score is

The average score is 0%

About the Applied Air Leakage Checks practice quiz

This practice quiz focuses on Applied Air Leakage Checks, listed under CDL Practice — Air Brakes. Use it to check what you understand, spot topics to revisit, and connect the material to safe, informed decisions on the road.

Before you begin

Keep your current CDL manual or course notes nearby. Read each prompt carefully and think through why an answer fits, especially when a question describes a vehicle, road, or workplace situation. Licensing rules and procedures can vary, so confirm requirements with current official materials for your state.

After you finish

Review any explanations shown with your results. Note unfamiliar terms or missed concepts, then revisit your manual or course notes before trying again. Use your score to guide study; understanding why an answer is correct matters more than the number alone.

Study note: These quizzes are independent study practice. They are not state licensing exams, official government materials, or ELDT certification, and they do not replace required training.

Explore CDL Tests to find more practice by subject.